Charnwood W015P Floorstanding Router Table Package Deal

The package consists of:

• W015 Router Table
• W026 NVR Switch
• CE12 Extension Collet 1/2" 

Features

• Large Fence, 2 x 460mm x 150mm
• Two adjustable vertical hold down feather boards
• Adjustable horizontal feather board
• Set of four fence shims to allow the outfeed fence to be stepped out up to 4.5mm
• Centralising jig to allow the router to be easily lined up in the centre of the aperture
• Redesigned universal router clamps to allow removal and refitting of the router in under a minute without losing your settings
• Scale mounted in the table for setting the fence 

• NVR Switch Included in Package
• Collet Extension Included in Package
• Cast Iron Main Table
• Hinged Top with Gas Filled Springs
• 2 Hold Down Feather Boards
• Large Aluminium Sliding Table
• Fence and Work Clamp for Tenons
• 70mm Diameter Extraction Outlet
• Floorstand With Shelf Included

Our router table will convert any hand held router into a stationary machine offering several advantages such as quicker set up times, improved safety and the ability to use much larger diameter cutters than is possible when working freehand.

W015 is a heavy duty routing table with a strong steel floorstand and a table top of cast iron. The front half of the table is actually a sliding bed and is fitted with a fence and work clamp to make short work of end grain cutting and tenons. This cross cut fence can be fitted anywhere along the length of the table and can also be locked in at 45 degrees.

Secure clamping of the work piece is achieved by setting the 2 fence mounted feather boards, to hold the work down against the table top and the front feather board to hold the work up against the fence. Using this method edge mouldings can safely be cut onto small pieces such as beading or picture frames.
There is also a scale mounted into the table to act as a guide when setting the fence.

The new centralising jig allows you to set your router accurately into the middle of the aperture within seconds. It also holds the router in place whilst you set the clamps underneath the table so you no longer need 2 pairs of hands!
The new design of router clamps is ideal for users who want to regularly remove the router and then refit it without losing the settings, saving time and effort.

For the odd job where the whole face is being removed, a set of shims are supplied that can be added to the outfeed fence to step it out and provide support to the work piece. Four shims are supplied allowing up to a 4.5mm step in 0.5mm increments.

Any sized router can be mounted to this table using the clamping set provided. To give easy access to the router when changing settings the whole table top is hinged and supported by gas filled struts to counteract the heavy weight of the cast iron top.

Package Supplied with W026 NVR Switch, CE12 60mm extension for 1/2'' routers, 2 removable insert rings, router mounting clamps, dust extraction outlet 70mm diameter.

Use our reducer 100/63RC to convert for 100mm diameter hose extraction systems.

Specification