HiKoki 36V Brushless SDS-Max Hammer Drill (2x4AH Batts)

Electric(AC)Performance without the Cord

The MULTI VOLT DH36DMA cordless rotary hammer is our first SDS-max cordless rotary hammer that uses the high-power BSL36B18
MULTI VOLT battery and a brushless motor. It delivers a drilling speed and demolition performance comparable to its corded counterpart.

• Drilling Speed*

  Speed of the DH40MC rotary hammer indexed at 100.

  When drilling a Ø25mm hole into concrete with compressive strength of 2,352N/cm² (240kgf/cm²).

  

• Demolition Performance*

  When demolishing concrete with a compressive strength of 2,352N/cm² (240kgf/cm²).

  

• Runtime per Charge*(with BSL36B18 battery)

  Approx. 25 Holes (Drilled in Ø25x60L Concrete)
  Approx. 11 Min. (Equivalent to 26kg Concrete Breaking) 

  

• Values shown are for reference purposes and may vary according to the workpiece materials and other operating conditions.

Robust Looks

• With part of its aluminum die-cast cylinder case and crank case
  exposed, the DH36DMA looks robust and sophisticated.

  

Ease of Use

• One-push Bit Mounting

  Only one action instead of the conventional two is required to mount a bit. All that needs to be done is to insert the bit into the tool holder while turning it.

  

• Large Change Lever

  Large change lever is located on top of the tool body for easy visibility and smooth mode changing.

   Hammering (for demolition)
   Neutral (for multiple bit-angle settings)
   Rotation + Hammering (for drilling)

  

• Low Vibration Handle

  The HiKOKI low vibration handle, which consists of the upper unit with rubber dampers and the lower unit with a hinge, reduces vibration and user fatigue, offering high productivity.

  

Display Lamp
RPM	260	340	410	590
BPM	1,420	1,850	2,240	2,860

Safety

• Battery Stopper

  A battery stopper helps prevent the battery from accidentally falling out of the tool. The battery cannot be removed unless both the stopper and the battery latches are released.

  

Reactive Force Control  

RFC

• When the tool bit is suddenly overburdened during operation, the slip clutch disengages the gears or the tool's built-in controller stops
  the motor's output before the entire tool jerks.

Caution

Depending on operating conditions, the Reactive Force Control function may not work or may not provide the
specified performance. Make sure that the workpiece is placed and supported properly, and that the main unit is held firmly during operation.

Specifications